![]() ![]()
Are you sure you don't have an issue when you select the TV input that the settings are not doing bass management or are not pumping the same signal level to the sub? Just a thought. Some AVRs allow you to have different speaker set ups and gain levels for different input sources. Maybe I will try turning the AVR all the way down and slowly increase it until the sub turns on. I have yet to have my SVS fail to power on regardless of the source. So, I wouldn't worry about the power consumption if left on all the time. The auto feature should disconnect the amp from the P/S. The P/S always draws power, but the amp only increases the power draw when it has a signal to amplify. The power usage, although it is really tiny to begin with, is no different because even when a sub goes into 'hibernation' when it's in Auto-ON mode, the amplifier stays on.īut some subs actually don't have the choice of being always ON it's either OFF or it's Auto-ON. Yes, this is most definitely the best option. And now when I go into the living room in the middle of the night I have a green nightlight. #Gale subwoofer manual manualI believe that I read in the sub manual to just leave it on all the time. Originally Posted by ressom I have an HSU with the same issue. Sounds like if you are usually listening at low volume levels, you may have to leave it on all the time. ![]() This is one of the reasons that when I'm listening to music at a very low volume level, I switch the LFE setting from subwoofer to mains on the receiver. For radio or CDs.įor TV, it comes on a little sooner. My PB12-NSD usually turns on when my digital master level at the receiver reaches -67.5. They don't fulfill the power demands of most smaller subs, let alone mid to larger size subs. No, switched receiver outlets, for subs, are not a great idea. Any idea of how much power it draws when it's not working? I thought the switched outlets weren't a good idea either-all I have running off of mine is a fan. Right now, I'm just leaving the sub on all the time, but like I said, I was concerned that it's drawing a significant amount of power. It's usually red when I'm watching TV-even when there's actually some bass there. It's red when it's in standby mode, and green when it's on. There is a power light on the back of it. Is there a power light on the back of it? I have mine in an enclosure so I can not see the back of it. I don't think receiver switched outlets are intended for sub woofer use are they? I would suggest turning the auto-off mode off also.Īre you sure it is not turning on when you have it at a very low volume? I have that sub and it is very hard to tell when it is off at low listening levels. So, I'm wondering, would it be possible to use a current-sensing switch (like they use with 12V triggers, for example, ), so that when my receiver turned on, my sub would too, and when my receiver goes off, so does the sub? Or would this give some sort of adverse results? Originally Posted by eugovector If your receiver has a switched outlet, you can also just plug your sub into that. Now, I know the solution is to just leave the sub on all the time, but that seems like it would be constantly drawing power (is it drawing much? It seems like it must be drawing enough to warrant a signal-sensing feature). I've tried turning the sub's gain down and the receiver's sub-out up, but it doesn't really solve the problem. The problem is that it doesn't always come on when I'd like it to (for example when watching TV, because we watch at a much lower volume than we do with movies). Hi, I just got my SVS PB-10 NSD, and as with my last sub (a Velodyne CHT-8), it has an auto-off sensing feature. #Gale subwoofer manual softwareWhen you upload software to you get rewarded by points. #Gale subwoofer manual utorrentUTorrent 2.0.4 main window is the part of the uTorrent interface that you'll likely be interacting with the most. Fast downloading of files through sharing and simultaneous transfer is now at a new level with uTorrent. Reference 1230W Car Subwoofer Owners Manuals, User Guides. View and Download Gale 4070 owner's manual online. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |